W1701 1HP Shaper
Router Bit Installation
Before using router bits, you should convert the shaper to a router table. Refer to Table Spacer Kit on Page 23 to learn how to do this.
The Model W1701 comes with a 1⁄2" and 1⁄4" router bit collet. When installing router bits, make sure that the router bits are secure before starting the machine. A loose router bit may fly out of the spindle.
To install the router bit collet, do these steps:
1.DISCONNECT SHAPER FROM POWER SOURCE!
2.Push the collet into the collet nut until the
Note: This lip and groove pulls the collet from the spindle when the collet nut is removed.
3.Place the collet nut and collet into the spindle. See
Figure 27.
4.Finger tighten the collet nut onto the spindle until it is flush with the top of the collet nut.
5.Insert the router bit.
6.Using the 26mm special flat wrench, insert it under the table and hold the spindle stationary (see Figure
Figure 26. Router bit collet in collet nut.
Figure 27. Installed collet flush with top
of collet nut.
A
B
Use 26mm Flat
Wrench Here
OPERATIONS
