W1701 1HP Shaper

OPERATIONS

To install cutters and rub collars, do these steps:

1.DISCONNECT SHAPER FROM POWER SOURCE!

2.Slide the cutter(s) and rub collars onto the spindle in the correct orientation for your intended cut.

3.Install the keyed safety washer and nut as shown in

Figure 24.

CUTTER FLY-APART HAZARD!

Always use the keyed safety washer! The lock tang on this washer prevents the shaper cutter bit from loosening the spindle nut during operation.

4.Thread on and tighten down the spindle nut with the provided 23mm wrench, while holding the spindle at the top with an 8mm wrench, as shown in Figure 25.

5.Make sure the cutter rotates freely in the correct direction needed for the cut (in most cases this is the FWD direction on the FWD/REV switch, which is counterclockwise on the spindle).

6.Install applicable safety guard(s).

AMPUTATION/LACERATION

HAZARD!

Accidental contact with a cutter during operation will remove parts of fingers or large chunks of flesh. Safety guards greatly reduce this risk and must always be used when operating this machine!

Keyed

Safety

Washer

Figure 24. Placing the keyed safety

washer.

Figure 25. Tightening spindle nut.

-16-

Page 19
Image 19
Woodstock W1701 owner manual To install cutters and rub collars, do these steps, AMPUTATION/LACERATION Hazard