Introduction, Woodstock Technical Support | Woodstock W1701 manual

INTRODUCTION

W1701 1HP Shaper

INTRODUCTION

Woodstock Technical Support

We stand behind our machines! In the event that questions arise about your machine, parts are miss- ing, or a defect is found, please contact Woodstock International Technical Support at (360) 734-3482 or send e-mail to: tech-support@shopfox.biz. Our knowledgeable staff will help you troubleshoot prob- lems and send out parts for warranty claims.

If you need the latest edition of this manual, you can download it from http://www.shopfox.biz. If you have comments about this manual, please contact us at:

Woodstock International, Inc.

Attn: Technical Documentation Manager

P.O. Box 2309

Bellingham, WA 98227

Specifications

Motor Size	1HP, 110V, 60 Hz	Single-Phase
Motor Speed		3,450 RPM
Amps		13
Spindle Size		1⁄2"
Spindle Max Cutter Height W/Bushings, Nuts, and Rub Collar		21⁄2"
Maximum Cutter Diameter		27⁄8"
Spindle Travel		7⁄8"
Spindle Speed		13,200 RPM
Table Size	24" Wide x 19" Deep
Stand	Powder Coated Paint
Footprint	187⁄8" Wide x 165⁄8" Deep
Dust Port		N/A
Power Transfer		Belt Drive
Bearings	Shielded and Permanently Lubricated Ball Bearings
Switch	Forward and Reverse Toggle
Machine Weight		200 lbs.

-2-

Image 5

Woodstock W1701 owner manual Introduction, Woodstock Technical Support, Specifications

Contents

Copyright FEBRUARY, 2008 by Woodstock INTERNATIONAL, INC Model W1701PART# Description HP Shaper Page Contents Woodstock Technical Support SpecificationsIntroduction Standard Safety Instructions Safety Always Lock Mobile Bases if Used Before Operating Machinery Additional Safety Instructions for Shapers Use a Shop FOX Featherboard as Anti-kick back protection Avoiding Potential Injuries 110V Operation ElectricalExtension Cords Grounding Unpacking SET UPInventory Lifting Hazard Cleaning Machine Machine PlacementMain Contents Qty Inventory List Laceration Hazard Assembly Test Run Cutters vs. Router Bits OperationsGeneral Spindle Direction Spindle ElevationTo set the spindle height, do these steps Cutter Contact Hazard Table Inserts Fence PositioningFence Alignment There are three set up positions for rub collars Cutter InstallationAccidental START-UP Hazard Cutter FLY-APART Hazard AMPUTATION/LACERATION Hazard To install cutters and rub collars, do these steps To install the router bit collet, do these steps Router Bit Installation Straight Shaping To set up the fence for partial edge removal, do these steps Template Construction Tips Templates Starting pin operation Guard not shown for clarity Freehand Shaping Maintenance Schedule MaintenanceTable & Base Lubrication Belt Adjustment ServiceTo adjust belt, do these steps Loosen the belt adjustment bolts as shown in Figure Table Spacer Kit To install the table spacer kit, do these steps To replace the spindle cartridge assembly Spindle Cartridge Replacement Resurfacing a shaper fence on a Jointer ON/OFF Switch Motor & FWD/REV Switch Electrical Components & Wiring Parts PART# Description Parts List Cutterspindle Warranty Comments Warranty Registration BOX BELLINGHAM, WA Woodstock International INC