W1701 1HP Shaper
Spindle Elevation
Correct spindle height is crucial to most shaping applica- tions. Use a piece of test wood to confirm the correct spindle height before cutting expensive lumber.
To set the spindle height, do these steps:
1.Loosen the spindle lock knob located on the side of the shaper as shown in Figure 15.
2.Move the spindle height lever shown in Figure 16 to raise the spindle or left to lower the spindle.
3.Retighten the spindle lock knob on the side of the shaper. DO NOT
Figure 15. Spindle lock knob.
Spindle Direction
The Model W1701 is capable of operating in two directions by use of the forward and reverse switch shown in Figure 17.
It is very important that the workpiece be fed against the direction of the cutter rotation. This will prevent a climb cut and maintains a safe cutting procedure for the operator.
Most operations are done with the switch in the FWD position. However, there will be times when it is necessary to flip the shaper cutter over and run the spindle in the opposite direction (REV).
•When the switch is pointing to the FWD position, the spindle and cutter rotate counterclockwise.
•When pointing to the REV position, the spindle and cutter rotate clockwise.
CUTTER CONTACT HAZARD!
Feeding the workpiece in the same direction that the cutter is rotating may result in a climb cut, which can pull your hand into the cutter. Always feed the workpiece AGAINST the direction that the cutter is rotating to reduce this risk.
Figure 16. Spindle-height lever.
Figure 17. Forward and reverse switch.
OPERATIONS
