Belt Tracking Safety Switch | Woodstock W1709 specs

ADJUSTMENTS

Belt Tracking Safety

Switch

Belt tracking safety switches are placed on both sides of the belt to act as emergency machine stops if the belt travels too far to one side during oscillation. See Figure 16.

To adjust the belt tracking safety switches, do these steps:

1.TURN-OFF and LOCK the master power switch so no power can go to your sander!

2.Make sure the belt tracking and oscillation is adjusted.

3.Release the belt tension, center the sanding belt on the top roller, then re- tension the belt.

4.Measure the distance from the edge of the sanding belt to the ceramic rod protruding from the switch.

5.Loosen the adjustment bolt shown in Figure 16 and move the switch so the belt and the ceramic rod have approximately 1⁄2" clearance from each other.

6.Tighten the bolt and repeat the adjustment with the other side if necessary.

7.Start the sander and make sure it is working properly.

Adjustment

Bolt

Figure 16. Tracking safety switch and

adjustment bolt.

-16-

Image 18

Woodstock W1709 instruction manual Belt Tracking Safety Switch, To adjust the belt tracking safety switches, do these steps

Contents

Wide Belt Sander Page Contents Woodstock Service and Support IntroductionAbout Your New Sander Warranty and Returns Specifications Safety First Standard Safety InstructionsDisconnect machine when cleaning, adjusting or servicing Keep stable footing and balance at all times Additional Safety Instructions for Sanders Avoiding Potential Injuries Correct body and hand positioning Extension Cords Electrical Requirements220V Operation Grounding Assembly Box ContentsUnpacking Cleaning Machine Shop Preparation Air Hose Installation Sanding Belt Installation Dust Collection Dust collection adapters Adjustments General InformationPhoto-Electric Eye Belt tracking adjustment location Belt Tracking Belt oscillation adjustment Belt Oscillation Speed Belt Tracking Safety Switch To adjust the belt tracking safety switches, do these steps To adjust the pressure rollers, do these steps Pressure Rollers Belt Tension To tension the V-belts, do these steps To adjust the feed belt tension and tracking, do these steps Feed Belt Tension Tracking Table Stop Switches To adjust table stop switches, do these stepsDown Key Operations Control Panel Test Run Selecting SandpaperTo complete the test run, do these steps Setting Feed Speed Using the Load MeterTo change the feed belt speed do these steps Calibrating the Table Emergency StopKeypad and Display To apply the emergency stop, do these steps Basic Sanding Quick TipTo sand a workpiece, do these steps Maintenance GeneralLubrication Cleaning Belts Servicing Separators Brake assembly Pads Servicing Brake Changing V-Belts Figures Troubleshooting Symptom Possible Cause HOW to Remedy W1709 Wiring Diagram W1709 Control Panel Wiring Connections W1709 Switch Box Wiring Connections Parts Tool BOX Parts Elevation Screw Parts Conveyor Table Parts Piston Roller Shaft Parts Parts Parts Electrical Control BOX Accessories D3003 15 x 20 Cleaning Pad for Wide-Belt Sanders Warranty Card BOX BELLINGHAM, WA