Woodstock W1772, W1773 owner manual Gear Oil Check, To check the gear oil, do these steps

W1772/W1773 37" Drum Sander

SET UP

2.Feed the power wires through the strain relief on the bottom of the control panel, tighten the strain relief, connect the cord to the terminals shown in Figure 18 or 19, and reinstall the control panel face plate.

Note (Model W1773 Only): When using a phase con- verter, connect the manufactured power leg to the L1 terminal (Figure 19). The L1 terminal can handle power fluctuation because it is wired directly to the motor. The other wires connect to the controls and must be consistent to prevent damage.

3.SHUT OFF THE MAIN POWER AT THE POWER SOURCE CIRCUIT BREAKER and attach the wires to the locking shutoff switch.

Gear Oil Check

It is important to make sure the gear box has adequate oil in it before running the sander for the first time, to ensure the gears do not burn up.

To check the gear oil, do these steps:

1.Remove the shipping seal from the side of the vent- ed fill plug (Figure 20), if not already done so.

2.Check the sight glass shown on the back of the gear box to make sure gear oil is present.

3.If the gearbox oil level is low, follow the steps on Page 30 to refill the oil.

Strain

Relief

Ground

Figure 18. W1772 control panel wiring.

Strain

Relief

Ground

Figure 19. W1773 control panel wiring.

	Sight Glass
Shipping Seal
Inserted in
Vented Fill Plug	Gear Box

Figure 20. Typical vented fill plug (sight

glass not shown).

-20-