W1772/W1773 37" Drum Sander
Test Run
Once the assembly is complete, test run your machine to make sure it runs properly and is ready for regular opera- tion.
The test run consists of verifying the following: 1) The motors power up and run correctly, 2) the motors turn the correct direction (machine is not wired out of phase (W1773 only), and 3) the stop button safety feature works correctly.
If, during the test run, you cannot easily locate the source of an unusual noise or vibration, stop using the machine immediately, then review Troubleshooting on Page 56.
If you still cannot remedy a problem, contact our Tech Support at (360)
To test run the drum sander, do these steps:
1. | Make sure you understand the safety instructions |
| at the beginning of the manual, and verify that the |
| machine is setup properly. |
2. | Make sure the feed motor gearbox is full of oil and |
| the shipping seal is removed from the vented fill |
| plug. |
3. | Ensure all tools and objects used during setup are |
| cleared away from the machine, and all covers and |
| panels are closed. |
4. | Push the EMERGENCY STOP button in, then twist |
Loose hair and clothing could get caught in machinery and cause serious personal injury. Keep loose clothing rolled up and long hair tied up and away from machinery.
� | � |
��� | |
�������� | ������������ |
��������� | ���������� |
���
Figure 21. Resetting the switch.
Feed Drum
Motor
SET UP
it clockwise so it pops out. When the EMERGENCY |
button pops out, the switch is reset and ready for |
operation (see Figure 21). |
5. Model W1772: Press the CONVEYOR START button. |
—If any problems occur, press the EMERGENCY STOP BUTTON.
Model W1773: Verify that the power is not connect- ed out of phase by pressing the CONVEYOR START button, using the criteria below:
—If the top of the conveyor belt moves toward the back of the machine, it is moving in the correct direction.
Sanding Drum
Motor Relay
Relay
