Woodstock W1812 manual FGI8K@FEJ

N(/()Fne\ijDXelXcD]^%j`eZ\*&'0

—If a certain moulding knife profile does not allow you to adjust the outfeed roller down far enough for proper roller traction, the eccentric stop must be repositioned to the lower hole. To do this, remove the jam nut (Figure 28), reposition the eccentric stop (Figure 29) in the lower hole, and finger tighten the jam nut. Next rotate the eccen- tric stop to lower or raise the roller and retighten the jam nut.

Lower

Jam Nut

Hole

FG<I8K@FEJ

3. Loosen and back off the four spring tensioner jam nuts (=`^li\30) completely, and unthread the ten- sioner assemblies until you are sure that they are not touching the springs.

+. Thread the tensioners back into the housings until you feel the tensioner just contact the springs.

,. Give each tensioner approximately two full turns to preload the springs and tighten the jam nuts.

-. Reinstall the chip deflector.

=`^li\28.Feed roller stop adjustment.

Eccentric Stop

=`^li\29.Eccentric stop.

=`^li\30.Feed roller tension adjustment.

-22-