Woodstock W1812 manual Dflc`e f j Xe fe kj, =fid`e Be`\ c\XiXeZ

	N(/()Fne\ijDXelXcD]^%j`eZ\*&'0
Dflc[`e^;fjXe[;fekj
The Model W1812 will accommodate most moulding knife
profiles. However, you still must pay special attention to	CORRECT
workpiece support and knife-to-table clearance. Refer to
the following examples to avoid common workpiece setup
mistakes.
REMEMBER, moulding knives have many different pro-
files, before starting the machine, always verify that	CORRECT
the moulding knives do not contact any part of the
workpiece guide rails, feed roller swing arm, or the
table surface. =X`cli\ kf m\i`]p be`]\ Zc\XiXeZ\ dXp
i\jlck`ej\m\i\`ealipXe[dXZ_`e\[XdX^\
<[^\=fid`e^Be`]\:c\XiXeZ\	Custom
A wooden sacrificial table clamped to the cast iron table	3-Piece
	Guide
and a three-piece guide system (Figure 36) will prevent
	Rail System
tool and table damage by absorbing the full sweep of the
	Mounted to
knife.
	the
Never attempt to use edge forming profile knives with-	Sacrificial
	Table
out pre-installing a wooden sacrificial table. Often these
types of knives sweep lower than the workpiece and will
contact the table, causing severe machine damage or
personal injury.
	Top View
	INCORRECT
	Figure 36. Edge forming profile hazards.

G8IKJ

-26-