N(/()Fne\i jDXelXc D]^%j`eZ\*&'0
K\jkIle
If, during the test run, you encounter an unusual noise or vibration, stop using the machine immediately, then review KiflYc\j_ffk`e^ on GX^\+) for correction. If you still cannot remedy a problem, contact our Tech Support at (360)
Kfk\jkilek_\dXZ_`e\#[fk_\j\jk\gj1
(. Make sure you understand the safety instructions at the beginning of the manual, and verify that the machine is setup properly.
). Ensure all tools and objects used during setup are cleared away from the machine.
*. Use the elevation handwheel to raise the planer/ moulder head to provide plenty of room for the safe operation of the feed rollers and the cutterhead.
+. Pull out the chip deflector retaining pin (=`^li\17) and remove the chip deflector.
,. Wearing leather gloves, use a 14mm wrench to make sure the knives are tight, and rotate the cutterhead to make sure the knives do not hit the table.
.. Push the OFF button in, then turn it clockwise so it pops out (=`^li\(/) to ensure it resets.
/. Turn the speed control dial (=`^li\(/) counterclockwise to its slowest setting, then push the ON button and the main motor will start.
0. Turn the speed control dial clockwise to operate and speed up the feed rollers.
('. Press the OFF button to stop the machine.
((. WITHOUT resetting the OFF switch, press the ON button. The machine should not start.
—If the machine does not start, the OFF button safety feature is working correctly.
—If the machine starts, immediately disconnect the machine from power. The OFF button safety feature is at fault and must be replaced before using this machine.
Gifa\Zk`c\j k_ifne ]ifd k_\ dXZ_`e\ Zflc[ ZXlj\ j\i`flj \p\ `ealip. N\Xi jX]\kp ^cXjj\j kf i\[lZ\ k_\ i`jb f] `ealip.
=`^li\17.Removing the chip deflector.
=`^li\(/. Control panel.
