Woodstock W1812 manual @ejkXcc`eDflc`eBe`m\j, Kf`ejkXccdflc`ebe`m\j#fk\j\jk\gj1

N(/()Fne\ijDXelXcD]^%j`eZ\*&'0

@ejkXcc`e^Dflc[`e^Be`m\j

REMEMBER, moulding knives have many different pro- files, before starting the machine, always verify that the moulding knives do not contact any part of the workpiece guide rails, feed roller swing arm, or the table surface. =X`cli\ kf m\i`]p be`]\ Zc\XiXeZ\ dXp i\jlck`ej\m\i\`ealipXe[dXZ_`e\[XdX^\

Kf`ejkXccdflc[`e^be`m\j#[fk_\j\jk\gj1

(. DISCONNECT THE PLANER/MOULDER FROM POWER!

Chip

Deflector

=`^li\23.Removing the chip deflector.

FG<I8K@FEJ

). Pull the pin shown in =`^li\23, and remove the chip deflector.

*. Put on heavy leather gloves, and use a 14mm wrench to remove the knife bolts, washers, and any knives (if installed).

+. Remove any dust, wood chips, and pitch from the cutterhead knife seat and lip (=`^li\24).

,. Place the moulding knife against the cutterhead lip with the beveled side of the blade facing up (=`^li\ 24), and in the inboard position (=`^li\25) leaving only one set of holes (=`^li\25). Should you for any reason need to position moulding knives on the outboard position of the cutterhead, you must leave one set of holes exposed if the at that end also.

-. Line up the holes and secure the knife to the cutterhead with the knife bolts and washers (=`^li\ 25).

.. Make sure the knife did not move away from the cutterhead lip when tightened, then rotate the cutterhead to the bottom.

/. Install the other moulding knife.

0. Set the guide rail alignment for clearance, and set the depth stop to maintain moulding knife to table clearance.

10.Adjust the feed rollers and spring tension as outlined in Feed Roller Height and Spring Tension on Page 21.

Bevel Side

Up

Lip
=`^li\24.Moulding knife installation.
	Inboard Side
	For Clearance
	Safety, Leave These
	Holes Exposed If
Outboard Side	Using Some Larger
	Moulding Knives
=`^li\25.Knives positioned inboard.

-20-