Woodstock W1812 manual Dflc`eKXccNfibg`\Z\j

N(/()Fne\ijDXelXcD]^%j`eZ\*&'0

<[^\Dflc[`e^KXccNfibg`\Z\j

When cutting edge profiles on workpieces that are taller than they are wide, you must clamp wooden extension rails to the table so they support at least 75% of the workpiece height on both sides (Figure 41).

Never attempt to use the low profile metal guide rails that came with this machine if they do not adequately support the workpiece, such as with tall workpieces. If the workpiece slips out of rails because the rails are too low, the workpiece can be ejected from the machine causing severe injury.

CORRECT

INCORRECT

Figure 41. Correct workpiece support.

FG<I8K@FEJ

-29-