Woodstock W1812 manual Loom

N(/()Fne\ijDXelXcD]^%j`eZ\*&'0

((. Feed the switch pedestal wiring harnesses into the cabinet through the hole in the cabinetand secure the switch pedestal to the cabinet (=`^li\13)with three 5⁄16"-18 x 3⁄4" hex bolts and 5⁄16" flat washers.

(). Plug the harnesses into their respective sockets just below the pedestal mounting.

(*. Insert the feed motor wiring harness through the conduit and loom clamps, and then plug it into the motor.

(+. Fasten the conduit mounting bracket (=`^li\14) to the headstock with two 5⁄16"-18 x 3⁄8" flange screws.

Switch

Pedestal

Mounting

Bracket

=`^li\13.Switch pedestal installation.

	Wiring
	Harness
Conduit	and
Mounting	Loom
Bracket	Clamps

J<KLG

(,. Install two T-nuts in each table slot (=`^li\15).

(-. Position the inner and outer guide rails so the elongated T-nut slots (=`^li\15)are positioned on the infeed table.

(.. Insert the lock levers through the guide rails, and then thread them into the T-nuts.

(/. Snug the levers in place.

-15-

=`^li\14.Conduit installation.

Inner	Slot
and
outer
Rails

=`^li\15.Rail installation.