Woodstock W1820, W1819 manual 8jj\dYcp, KfXjj\dYc\k\kXYc\jXn#fk\j\jk\gj1

Df[\cN(/(0&N(/)'D]^%J`eZ\('&('

8jj\dYcp

Assembly steps are the same for the Model W1819 and W1820 except where noted. Assembly consists of install- ing minor components, the extension wings, front and rear rails, extension table, and the legs (Model W1820 only).

KfXjj\dYc\k_\kXYc\jXn#[fk_\j\jk\gj1

(% Pull the magnetic switch out of the saw cabinet and install the door by inserting the door pins into the hinge sockets on the cabinet (see =`^li\ /).

Hinge

Socket

=`^li\/% Door installed.

)% Place the included 5 x 5 x 40 key in the handwheel shaft and slide the handwheel onto the shaft on the front of the table saw. Use the included 2.5mm hex wrench to tighten the set screw (see =`^li\0) on the side of the handwheel until it is secure.

J<KLG

=`^li\0% Handwheel set screw.

*% Thread the handwheel lock knob into the center of the handwheel and tighten, then install the handle into the handwheel and tighten with a 14mm wrench (see =`^li\(').

Lock Knob

Handle

+% Remove the shipping brace (see =`^li\(() using a 17mm wrench and a pair of needle nose pliers. Re-install the M10-1.5 x 25 hex bolt, flat washer, hex nut and the cotter pin, and save the shipping brace.

=`^li\('% Handwheel installed.

Shipping Brace

=`^li\((% Shipping brace location.

-22-