Woodstock W1820, W1819 manual =\eZ\ D`k\iXl, DXe\k`ZJn`kZ, JXn9cX

Df[\cN(/(0&N(/)'D]^%J`eZ\('&('

J<KLG

,% Adjust the extension table so it is flat (both flush and parallel) with the main table, using a long straightedge (similar to the method shown in =`^li\

))). This can be done by loosening the mounting bolts and adjusting the feet up/down as needed.

-%Tighten the extension table mounting bolts, and tighten the hex nuts on the feet up against the legs so they will not move.

=\eZ\D`k\i>Xl^\

(% Attach the fence handle to the fence and thread the rear rail foot into the bottom of the fence (see =`^li\)+).

)% Place the fence on the rails on the right hand side of the blade (see =`^li\),).

Efk\1DXb\jli\k_\ZXd]ffkZfekXZkjk_\ZXdfe k_\]\eZ\cfZb_Xe[c\Y\]fi\pflgcXZ\k_\]\eZ\fe k_\iX`c#fk_\in`j\k_\]\eZ\n`ccefkcfZbfekfk_\ iX`cklY\%

*% Slide the miter gauge into the T-slot on the left hand side of the blade.

Rear Foot

Handle

=`^li\)+% Fence assembled.

	Cam
Cam
	Foot

DX^e\k`ZJn`kZ_

(% Install the magnetic switch onto the bottom left hand side of the front rail using two M6-1 x 12 hex bolts, 6mm lock washers, and 6mm flat washers, as shown in =`^li\)-.

)% Secure the top of the switch to the rail with an M6-1 x 12 Phillip head screw, 6mm lock washer, and flat washer.

JXn9cX[\

(% Remove the table insert by unscrewing the screw that fastens it to the table.

)% Raise the arbor all the way up and set the blade angle at 0º.

*% Remove the arbor nut and arbor flange from the arbor, slide on the included 10" saw blade, making sure the teeth face the front of the saw, then install the arbor flange and arbor nut onto the blade. See GX^\*, for additional details.

=`^li\),% Fence installed on rails.

=`^li\)-%Magnetic switch installed.

-26-