Woodstock W1819, W1820 manual IfjjZlkk`e, KfdXb\XZifjjZlklj`ek\d`k\iXl\#fk\j\ jk\gj1

Df[\cN(/(0&N(/)'D]^%J`eZ\('&('

:ifjjZlkk`e^

"Crosscutting" means cutting across the grain of a natural wood workpiece. In other man-made materials, such as MDF or plywood, crosscuttting means cutting across the width of the workpiece.

KfdXb\XZifjjZlklj`e^k_\d`k\i^Xl^\#[fk_\j\ jk\gj1

(% DISCONNECT THE SAW FROM POWER!

)% Ensure that the blade guard/spreader is installed.

*% Move the rip fence aside and position the miter gauge, adjusted to 90°, in a miter slot.

+% Adjust the blade height so the teeth protrude approximately 1/4" above the workpiece.

,% Slide the miter gauge near the blade and adjust the workpiece so the blade will cut on the waste side of the line.

-%Plug in the table saw, turn it FE# and allow it to reach full speed.

.% Hold the workpiece firmly against the face of the miter gauge (see =`^li\,)) and ease it through the blade until the workpiece is completely past the saw blade.

=`^li\,)%Typical crosscutting operation.

KlieF==k_\jXnXe[Xccfnk_\YcX[\ kf Zfd\ kf X Zfdgc\k\ jkfg Y\]fi\ i\dfm`e^ k_\ Zlk$f]] g`\Z\% =X`cli\ kf ]fccfn k_`j nXie`e^ Zflc[ i\jlck `e j\i`fljg\ijfeXc`ealip%

B\\gk_\YcX[\^lXi[`ejkXcc\[Xe[`e k_\ [fne gfj`k`fe% =X`cli\ kf [f k_`j Zflc[i\jlck`ej\i`fljg\ijfeXc`ealip fi[\Xk_%

FG<I8K@FEJ

-41-