Df[\cN(/(0&N(/)' D]^%J`eZ\('&('
KfYl`c[k_\Xlo`c`Xip]\eZ\#[fk_\j\jk\gj1 |
|
|
(% Cut the auxiliary fence board to size. If you are using |
|
|
hardwood, cut the board oversize, then joint and |
|
|
plane the board to the correct size to make sure the | =\eZ\ |
|
board is square and flat. |
| |
=\eZ\ 9f[p |
| |
| 8lo`c`Xip | |
Efk\1Fecplj\]lie`kli\^iX[\gcpnff[fib`ce[i`\[ | =XZ`e^ | |
| =\eZ\ | |
_Xi[nff[kfgi\m\eknXig`e^% |
| |
|
| |
)% Unthread the fence face mounting hardware and |
|
|
remove the fence face from the fence assembly. |
|
|
*% Place the auxiliary fence next the fence face you |
|
|
removed in Jk\g(, mark the location of the nine | =`^li\67% Auxiliary fence. | |
mounting holes on the auxiliary fence, then drill the |
|
|
holes. |
|
|
+% Use the mounting hardware that had previously attached the fence face to attach the auxiliary fence. The end result should be similar to =`^li\67.
I\jXn`e^Fg\iXk`fej
The table saw motor is pushed to its limits when resawing. If the motor starts to bog down, slow down your feed rate. Motor overloading and blade wear can be reduced by using a ripping blade. Ripping blades are designed to clear the sawdust quickly.
:fdgfe\ekjE\\[\[]fiI\jXn`e^1 |
|
Zero Clearance Insert | 1 |
Ripping Blade 10" | 1 |
Clamps | 2 |
Shop Made Auxiliary Fence | 1 |
Shop Made Resaw Barrier | 1 |
Kfg\i]fidi\jXn`e^fg\iXk`fej#[fk_\j\jk\gj1 |
|
(% DISCONNECT THE SAW FROM POWER! |
|
)% Remove the standard table insert and the blade |
|
guard assembly. |
|
*% Install a ripping blade and the riving knife, lower the blade below the table, then install a zero clearance table insert.
Pfl dXp \og\i`\eZ\ b`ZbYXZb [li`e^ k_`j gifZ\[li\% JkXe[ kf k_\ j`[\ f] k_\YcX[\Xe[n\XiX]lcc]XZ\j_`\c[kf gi\m\ek`ealipn_\ei\jXn`e^%
FG<I8K@FEJ
