|
|
|
| Df[\cN(/(0&N(/)' D]^%J`eZ\('&(' | |
|
|
|
| ||
|
|
|
| ||
|
|
|
| ||
|
|
|
| ||
Symptom | Possible Cause | Possible Solution |
| ||
Blade is not aligned with | 1. | Blade is warped. | 1. | Replace blade (GX^\*,). |
|
miter slot or fence. | 2. | Table top is not parallel to blade. | 2. | Make table parallel to blade |
|
| 3. | Fence is not parallel to blade. | 3. | Make fence parallel to blade (GX^\.'). |
|
|
|
|
|
|
|
Blade does not reach 90°. | 1. | 90° stop bolt is out of adjustment. | 1. | Adjust 90° stop bolt |
|
| 2. | Sawdust stuck on stop bolt. | 2. | Clean sawdust off stop bolt. |
|
|
|
|
|
|
|
Blade hits insert at 45°. | 1. | 45° stop bolt is out of adjustment. | 1. | Adjust 45° stop bolt |
|
| 2. | Sawdust stuck on stop bolt. | 2. | Clean sawdust off stop bolt. |
|
| 3. | Hole in insert is inadequate. | 3. | File or mill the hole in the insert. |
|
| 4. | Table out of alignment. | 4. | Align blade to the table |
|
| 5. | Blade position is incorrect. | 5. | Adjust blade position. |
|
|
|
|
|
|
|
Board binds or burns when | 1. | Dull blade. | 1. | Replace blade. |
|
feeding through table saw. | 2. | Blade is warped. | 2. | Replace blade (GX^\*,). |
|
| 3. | Fence is not parallel to blade. | 3. | Make fence parallel to blade (GX^\.'). |
|
| 4. | Table top is not parallel to blade. | 4. | Make table parallel to blade |
|
J<IM@:<
