Woodstock W1820, W1819 manual DXb`eI\jXn9Xii`\i, 8lo`c`Xip=\eZ

Df[\cN(/(0&N(/)'D]^%J`eZ\('&('

DXb`e^I\jXn9Xii`\i

FG<I8K@FEJ

The resaw barrier acts in tandem with the rip fence when resawing to provide tall support for the workpiece to minimize the probability of it binding against the blade and causing kickback.

KffcjE\\[\[]fik_\I\jXn9Xii`\i1
Table Saw		1
Jointer and Planer	Recommended
Clamps		2 Minimum
Drill and Drill Bits		1
:fdgfe\ekjE\\[\[]fik_\I\jXn9Xii`\i1
Wood* 3⁄4" x 6" x Length of Table Saw Fence		1
Wood* 3⁄4" x 3" x Length of Table Saw Fence		1
Wood Screws #10 x 2"		4
Wood Glue		As Needed

*Fecplj\]lie`kli\^iX[\gcpnff[#b`ce[i`\[_Xi[nff[# fiL?D?gcXjk`Zkfgi\m\eknXig`e^%

KfYl`c[k_\i\jXnYXii`\i#[fk_\j\jk\gj1

(% Cut your wood pieces to the size specified above. If you are using hardwood, cut the pieces oversize, then joint and plane them to the correct size to make sure they are square and flat.

)% Pre-drill and countersink 4 holes approximately 3⁄8" from the bottom of the 6" tall board. These will be use as pilot holes when attaching the board to another piece in the next step.

*% Glue the end of the 3" board, then clamp the boards at a 90° angle with the larger board in the vertical position, as shown in =`^li\--, fasten together with the wood screws.

#10 x 2"	3⁄4"
Wood Screw
3⁄4"	Assembled
	Resaw Barrier

=`^li\--%Clamping the resawing barrier.

8lo`c`Xip=\eZ\

The auxiliary fence is necessary if you are resawing a workpiece that is taller than it is wide. It should be no less than 1⁄2" shorter than the board to be resawn.

:fdgfe\ekjE\\[\[]fik_\8lo`c`Xip=\eZ\1

Hardwood or Plywood 3⁄4" x (Height) x Length of Table
Saw Fence	1
KffcjE\\[\[]fik_\I\jXn9Xii`\i1
Table Saw	1
Jointer and Planer	Recommended
Clamps	2 Minimum
	-50-