Df[\cN(/(0&N(/)' D]^%J`eZ\('&('
=\eZ\JZXc\:Xc`YiXk`fe
The fence scale indicator window, shown in =`^li\('/, can be calibrated with the fence scale if you notice that your cuts do not accurately match what is shown on the fence scale. The indicator adjusts by loosening the two mounting screws and sliding it in the desired direction.
KffcjE\\[\[ | Hkp |
Hex Wrench 2.5mm | 1 |
Scrap Piece of Wood | 1 |
KfZXc`YiXk\k_\]\eZ\jZXc\`e[`ZXkfin`e[fnj#[f k_\j\jk\gj1
(% Position and lock the fence at 13", as indicated by the scale, cut your scrap piece of wood.
)% Reposition and lock the fence at 12", as indicated by the scale.
*% Flip your scrap piece of wood over, placing the side that was cut in Jk\g) against the fence, and cut your scrap piece of wood.
+% Measure the width of the freshly cut workpiece with
a tape measure. The workpiece width should be exactly 12". If it is not, then adjust the indicator window to match the width of the workpiece.
Screws
Indicator
Window
=`^li\('/% Fence indicator window.
J<IM@:<
