Woodstock W1819, W1820 manual 8aljk`e8c`ed\ek, 8aljk`e9\ekJgi\X\i&I`m`eBe`

Df[\cN(/(0&N(/)'D]^%J`eZ\('&('
8[aljk`e^8c`^ed\ek
The spreader/riving knife mounting position can be
adjusted into alignment with the blade using the set
screws on the spreader/riving knife mounting block.
Gfjj`Yc\KffcjE\\[\[		Hkp
Hex Wrench 3mm ...............................................1
Hex Wrench 5mm ...............................................1					Cap
			Center		Cap
To adjust the spreader/riving knife position, do these					Screws
			Screw
steps:
1. DISCONNECT THE SAW FROM POWER!				Set Screw
)%	Remove the table insert.
*% Adjust each pair of set screws that controls the			8c`^ed\ek	Adjustment Block
	direction required to move the mounting block so		Qfe\
				Kfg:fekifc
	the riving knive can be aligned with the blade (see		D`jXc`^e\[
				J`[\ :fekifc	:fekifc	J`[\
	increments.
	=`^li\(')). Make sure to move both screws in even		Jgc`kk\ifi
			I`m`e^Be`]\
+% Re-install the table insert.			9cX[\	9fkkfd:fekifc
,%	Follow :_\Zb`e^8c`^ed\ek,Jk\gj(Æ*to determine
	if the spreader/riving knife is parallel with the blade
	and inside the "Alignment Zone."

=`^li\(')%Set screws for adjusting

— If the spreader/riving knife is in the alignmentspreader/riving knife position. zone, no additional steps are necessary.

—If the spreader/riving knife is still not in the alignment zone, continue adjusting the set screws on the mounting block as necessary to correctly position the spreader/riving knife.

-%Tighten the two cap screws on the mounting block to secure the spreader/riving knife adjustment.

8[aljk`e^9\ekJgi\X[\i&I`m`e^Be`]\

(% DISCONNECT THE SAW FROM POWER!

)% Bend the spreader or riving knife by hand while installed, then follow Jk\gj(Æ* in :_\Zb`e^ 8c`^ed\ek to determine if it is parallel with the blade and inside the "Alignment Zone" (refer to :_\Zb`e^8c`^ed\ek).

—If this does not work, remove it to straighten.

—If you cannot straighten it properly, replace it.

-69-

J<IM@:<