Woodstock W2000 manual Fence, Attaching the wood facing

B. Fence

The Rebel® has a two-part, split fence designed for either straight-line or offset shaping. Assembling the fence is quite simple and straightforward.

Step 1 - Choose one of the fence halves. Select two fence lock handles and insert the threaded ends into the 1/4'' flat washers and two holes on the bottom of the fence. Select two T-nuts and loosely thread onto the ends of the lock knobs. Line up the T-nuts with the slots in the router table and slide the fence onto the router table. Figure 4. Roughly lock the fence in position. Repeat this process for the other fence half.

Figure 4. Attaching the fence.

Step 2 - Attach the wood facings to the fence using the flat head screws, flat washers and hex nuts provided. Figure 5. Tighten for now; howev- er, you will notice that there are slots in the back of the fence for side to side adjustment. Side to side adjustment of the wood facings is dependent upon the overall diameter of the router bit. For maximum safety and support, adjust the wood facings as close to the router bit as possible. Check clearance before start- ing the router.

Figure 5. Attaching the wood facing.

W2000 Rebel® – 7