Xerox 6287 user manual Programming PFSs, Resetting PFSs to their Default Values, Ally!%Pp=Eeffgg

Page 4-2 6287 ALLY PLUS User’s Manual

Programming PFSs

Programming PFSs is similar to programming all other configuration options on the ALLY PLUS. As with general configuration options, a trigger and a terminator are required, and all values are entered in hexadecimal format. Additionally, a percent sign (%) is needed to tell the ALLY PLUS to program a PFS, rather than a general configuration option. Otherwise, programming PFSs is done the same way that general configuration changes are made. Refer to Section 3 — Configuration for detailed information on configuration changes.

PFS configuration changes take the following form:

!ALLY!%PP=EEFFGG;

!ALLY! is the trigger; the percent sign (%) indicates a PFS trigger, rather than a general configuration option trigger; PP represents the two-digit decimal PFS number; an equals sign (=) separates the character sequence from the PFS number; EEFFGG represents the string of two-digit hexadecimal characters for that PFS function; and a semicolon (;) is the terminator. Each PFS entry must be separated by a comma (,), and each command line must have its own trigger and terminator. Here are some examples:

!ALLY!%00=1B2B580D0A; set PFS %00 (power on)

!ALLY!%01=1B2B580D0A,%02=1B62; set PFSs %01 and %02 (reset and bold on)

Resetting PFSs to their Default Values

All PFSs can be reset to their factory default settings by sending the trigger, the percent sign and the terminator as shown:

!ALLY!%;

Individual PFSs can be reset to their default settings by sending the trigger, the percent sign, the PFS number and the terminator, as the examples below illustrate:

!ALLY!%03;

set PFS %03 (bold off) to its default setting

!ALLY!%04,%05;

set PFSs %04 and %05 (overstrike on and off) to their default settings