Operation

1

ZMU02858

1. Trim operating angle

EMU27871

Adjusting trim angle for manual tilt models

There are 4 or 5 holes provided in the clamp bracket to adjust the outboard motor trim an- gle.

1.Stop the engine.

2.Remove the trim rod from the clamp bracket while slightly tilting the outboard motor up.

1

ZMU02909

1.Trim rod

3.Reposition the rod in the desired hole. To raise the bow (“trim-out”), move the rod away from the transom.

To lower the bow (“trim-in”), move the rod to- ward the transom.

Make test runs with the trim set to different angles to find the position that works best for your boat and operating conditions.

EWM00400

WARNING

●Stop the engine before adjusting the trim angle.

●Use care to avoid being pinched when removing or installing the rod.

●Use caution when trying a trim position for the first time. Increase speed gradu- ally and watch for any signs of instabil- ity or control problems. Improper trim angle can cause loss of control.

NOTE:

The outboard motor trim angle can be changed approximately 4 degrees by shifting the trim rod one hole.

EMU27911

Adjusting boat trim

When the boat is on plane, a bow-up attitude results in less drag, greater stability and effi- ciency. This is generally when the keel line of

28