Manuals / Brands / Marine Equipment / Outboard Motor / Yamaha / Marine Equipment / Outboard Motor

Yamaha 6L2-28199-1L Treatment of submerged motor, OFF ON START

1 68

Download 68 pages, 2.68 Mb

Trouble Recovery

OFF ON START

ZMU01906

5.If equipped the choke knob, pull out it when the engine is cold. After the engine starts, gradually return the choke knob to its home position as the engine warms up.

ZMU04119

6.Insert the knotted end of the emergency starter rope into the notch in the flywheel rotor and wind the rope several turns around the flywheel clockwise.

7.Give a strong pull straight out to crank and start the engine. Repeat if neces- sary.

ZMU02928

EMU29760

Treatment of submerged motor

If the outboard motor is submerged, immediately take it to a Yamaha dealer. Otherwise some corrosion may begin almost immedi- ately.

If you cannot immediately take the outboard motor to a Yamaha dealer, follow the procedure below in order to minimize engine dam- age.

EMU29771

Procedure

1.Thoroughly wash away mud, salt, sea- weed, and so on, with fresh water.

ZMU01909

2.Remove the spark plugs and face the spark plug holes downward to allow any water, mud, or contaminants to drain.

Contents

Page Page To the owner Page Page Identification numbers record Emission control information Safety information Important labels Basic boating rules (Rules of the road) Other special situations Page Fueling instructions Propeller selection Start-in-gearprotection Main components Fuel joint Fuel gauge Fuel tank cap Air vent screw Tiller handle Throttle indicator Throttle friction adjuster Engine stop lanyard switch Engine stop button Choke knob for pull type Manual starter handle Steering friction adjuster Trim tab with anode Trim rod (tilt pin) Shallow water lever Warning system Page Installation Clamping the outboard motor Breaking in engine Preoperation checks Filling fuel and engine oil Ring Free Fuel Additive Gasoline and oil mixing (100:1) Operating engine Starting engine Page Warming up engine Shifting Stopping engine Trimming outboard motor Adjusting trim angle for manual tilt models Adjusting boat trim Tilting up and down Procedure for tilting up Procedure for tilting down (manual tilt models) Cruising in shallow water Cruising in other conditions Specifications Transporting and storing outboard motor Clamp screw mounting models Storing outboard motor Page Lubrication (except oil injection models) Cleaning and anticorrosion measures Cleaning the outboard motor Checking painted surface of motor Periodic maintenance Maintenance chart Greasing Cleaning and adjusting spark plug Checking fuel system Inspecting fuel filter Cleaning fuel filter Inspecting idling speed Checking wiring and connectors Exhaust leakage Water leakage Checking propeller Removing the propeller Installing the propeller Changing gear oil Cleaning fuel tank Inspecting and replacing anode(s) Checking top cowling Coating the boat bottom Page Troubleshooting Page Page Temporary action in emergency Emergency starting engine Treatment of submerged motor Page Important warranty information for U.S.A. and Canada Page YAMAHA MOTOR CORPORATION, U.S.A. OUTBOARD MOTOR TWO YEAR LIMITED WARRANTY Page Page IMPORTANT WARRANTY INFORMATION IF YOU USE YOUR YAMAHA OUTSIDE U.S.A. OR CANADA Page OUTBOARD MOTOR WARRANTY REGISTRATION ENREGISTREMENT DE LA GARANTIE DU MOTEUR HORS-BORD ATTN: WARRANTY DEPARTMENT