1
DISPLAY
2
TUNING
MEMORY DOWN UP
TIME ADJ HOUR MINUTE
Changes.3
TUNING
MEMORY DOWN UP
TIME ADJ HOUR MINUTE
Changes.
1 While the power is on, press the DISPLAY button to display the time. If the power is off, you can proceed to the next step.
2 While pressing the TIME ADJUST button, press the HOUR button and set the hour.
*Press the HOUR button once to advance the time by 1 hour. Press and hold to advance continuously.
3 While pressing the TIME ADJUST button, press the MINUTE button and set the desired time.
*Press the MINUTE button once to advance the time by 1 minute. Press and hold to advance continuously.
*The hour setting will not advance even if the minute advance from “59” to “00”.
To display the time by “second”While pressing the SEC button, the current time is displayed by minute and second.
To reset the second to “00”While pressing the SEC button, press the TIME ADJUST button.*If the current second is lower than 30, it is reset to 00.*If the current second is higher than 30, the minute is advanced by 1 minute and the second is reset to 00.
(If the current minute is “59”, in this case, the hour is also advanced by 1 hour.)
In the event of a power failure or when the AC supply lead is disconnected.The time display will go out, however, the clock will function for about 30 minutes without power supply. So you do not have to reset the time if the AC power supply is resumed within about 30 minutes.
When the AC power supply is resumed after more than 30 minutes pass without power supply, the time display will flash on and off to indicate that the time must be reset.
Note
If this system is left for several minutes without setting the time after the AC power lead of this system is connected to the AC outlet, there may be a case that the display is turned into a demonstration mode. (This mode is virtually unnecessary for using this system.)
In this case, first turn the power on by pressing the POWER switch to cancel the mode, and then set the time.
English