Receiver
1
CD Player
6
Tape Deck
4 | 5 | 3 | 2 |
|
| TUNER DIRECT |
|
| ||
| 1 | 2 | 3 | 4 | 5 | 6 |
| 1 | 2 | 3 | 4 | 5 | |
| 6 | 7 | 8 |
|
| |
| 6 | 7 | 8 | 9 | 0 | |
| A | B | C | D | E | |
|
| |||||
| TIME | PROG | TAPE | EDIT | +I0 |
|
|
|
| STOP | PLAY/PAUSE | CD |
|
5 | REPEAT | PRESET | A/B/C/D/E | TUNER |
| |
| DOWN | UP |
|
| 1 | |
RANDOM | PLAY | STOP | PLAY | TAPE | ||
DECK |
| REC/PAUSE |
| PHONO/AUX | ||
| A/B |
|
|
|
|
|
| EFFECT LEVEL | DSP | MODE | SP/PHONES |
| |
| - | + |
|
|
|
|
| POWER | SLEEP | DISPLAY | VOLUME |
| |
|
|
|
| - | + |
|
•When recording important selections, be sure to make a preliminary test to ensure that the desired source material is being properly recorded with good sound quality.
•The automatic recording level control circuit automatically controls the level of the input signal used for recording.
•Adjusting the VOLUME, BALANCE, TREBLE and BASS controls have no effect on the recorded sound.
If, however, the DSP is on, the DSP effect is recorded along with the source.*Music with DSP effect is suitable for listening to inside a car etc.•For the tape deck, the deck which can be used for recording is the DECK B only. When recording, be sure to load a tape into the DECK B cassette compartment.
CD synchronized recording
1 Select the CD player so that “CD” appears on the display
by pressing the INPUT selector
or 
button, and load the disc to be recorded.2 Load a tape into the DECK B cassette compartment.*Wind past the beginning part of the tape on which recording can not be performed.
3 When recording with the Dolby NR system, set the Dolby NR switch to B or C; if not, set it to OFF.
*For selection of the Dolby B or C position, refer to the “Dolby B and C Type Noise Reduction” on page 29.
4 Set the reverse mode switch as desired.When the tape is set so that side A faces you, recording will be done as follows automatically according to the selected reverse mode.
Side A only | Side A → Side | Side A → Side | |
B | B | ||
| |||
Side B only | Side B only | Side B only |
*The corresponding indicator will light up and the play direction indicators flash.
6 Start CD playback by pressing the play/pause button.*Before CD playback begins, recording automatically begins on the side of the tape now selected.