Yamaha CC-50 Automatic preset tuning, Notes, Receiver, operation, Memory back-up, To recall a preset station, After the automatic preset tuning is completed

TUNING OPERATION

	Automatic preset tuning
	You can also make use of an automatic preset tuning
	function. By this function, this unit performs automatic tuning
	and stores stations with strong signals sequentially. Up to 40
1	stations are stored automatically in the same way as in the
	manual preset tuning method on the previous page.
	1 Select the tuner so that “TUNER” appears on the display
Receiver	by pressing the INPUT selector	or	button.
	2 Press and hold the AUTO MEMORY button for about 2
	seconds.
	* The MEMORY and AUTO TUNING indicators will flash.
	This unit performs automatic tuning and received stations are
	programmed to A1, A2 ... A8 sequentially.
	After the automatic preset tuning is completed
	The display shows the frequencies of the first preset station
	(stored to A1).
	Check the contents and the number of preset stations by
2	following the procedure of the section “To recall a preset
	station” on the previous page.

To recall a preset station

Simply follow the procedure of the section “To recall a preset station” on the previous page.

Notes

•	The automatic preset tuning search will be performed
	through all frequencies until 40 stations are stored. If the
	number of received stations is less than 40, the search will
•	stop after searching through all frequencies.
	With this function, only stations with sufficient signal
	strength are stored automatically. If the station you want
	to program is weak in signal strength, tune to it in
	monaural manually and program it by following the
	procedure of the section “To store stations” on the
•	previous page.
	You can replace a preset station by another FM or AM
	(MW or LW) station manually by simply following the
	procedure of the section “To store stations” on the
	previous page.

Fundamental rules of internal automatic preset tuning		Memory back-up
operation		The memory back-up circuit prevents the programmed data
Basically, FM stations are programmed onto area A, B and C,		from being lost even if the AC supply lead is disconnected
and AM stations are programmed onto area D and E (MW		from the AC outlet or the power is cut due to temporary
stations are onto D and LW stations are onto E) in that order		power failure. If, however, the power is cut for more than one
automatically.		week, the memory may be erased. If so, it can be re-
*	If, for example, the number of received FM stations is not	programmed by simply following the Preset tuning steps.
	enough to fill up three areas (A, B and C), AM (MW or LW)
	stations are programmed closely from the preceeding
	empty areas. In such a case, AM (MW) stations are
	programmed from area B or C (and LW stations are from
	area C or D.)
*	Moreover, one area is programmed with stations of the
	same band only. If, for example, the last FM station is
	programmed to B4, B5–B8 will be programmed with no
	station, and AM (MW) stations are programmed from area
	C.

English

E-25