Yamaha CC-50 Timer play, HOW TO USE THE BUILT-INTIMER, For tuner:, For tape deck:, For CD player:, Setting procedure:, ➁ At source selecting mode

HOW TO USE THE BUILT-IN TIMER

			Timer play
			By using the built-in timer, you can set the time when the unit
			turns on and a source begins playing automatically, and the
			time when the unit turns off automatically.
			1	Prepare the source to be played.
				For tuner:
				Tune in to the station you will listen to.
				For tape deck:
Receiver				Load a tape into the cassette compartment.
				(If tapes are loaded in both the compartments, tape A
				takes priority of tape B, and is played back by the timer
				play.)
				For CD player:
			2	Load a disc on the disc table.
				Press the DISPLAY button.
2	2-➀	2-➁		Whenever the DISPLAY button is pressed, the display
				mode changes as follows.
				At each mode, make a setting for the timer play, referring
				to the setting procedure described below.
					→ ➀ Current time (TIMER on/off mode)
						→
						➁ Source selecting mode (TAPE, TUNER, CD)
						→
						➂ ON TIME/Time setting mode
						→
						➃ OFF TIME/Time setting mode
						→
						➄ Normal display mode

* The display mode will be changed to the next mode after about 8 seconds elapse automatically. If the mode is changed before the setting is completed, call the mode again by pressing the DISPLAY button once or more.

Setting procedure:➀ At the display of current time

Check to be sure that the current time is correct, and press the TIMER button so that “TIMER” appears on the display.

➁ At source selecting mode

Select the source (TAPE, TUNER or CD) to be played

by pressing the INPUT selector or button.

* If “TUNER” is selected, soon it is changed to the frequency display mode. In this mode, you can select the station to listen to with the timer play by using the BAND button, A/B/C/D/E button and TUNER PRESET DOWN/UP buttons.

E-38