Yamaha CC-50 Tape A or tape B playback, Receiver, Tape Deck, To stop playback, Direct operation, DECK A select button, DECK B select button

TAPE DECK OPERATION

1

Receiver

DECK A select buttonDECK B select buttonTape Deck

2 5 6 6 4 2

3

Tape A or tape B playback		English
1	Select the tape deck so that “TAPE” appears on the
	display by pressing the INPUT selector or button.
2	Open the DECK A or DECK B cassette compartment by
	pressing the EJECT button.
3	Load the tape into the DECK A or DECK B cassette
	compartment, and close the lid panel completely by
	pressing the upper part of the center of the panel as
	figured left.
	* If you loaded two tapes into both the DECK A and B
	cassette compartments, select the DECK A or B in
	which the tape to be played back is loaded by pressing
	the DECK A or B select button.

4 Set the Dolby NR switch to B or C if the tape has been recorded with Dolby noise reduction, and to OFF if Dolby NR was not used.

*For selection of the Dolby B or C position, refer to the “Dolby B and C Type Noise Reduction” on page 29.

5 Set the reverse mode switch as desired.

The reverse mode switch can be operated before or during playback, and changes tape playback as follows:

	Side A → Side	Side A → Side B
Side A only		Continuous
	B	play
		(8 times)
		Side B → Side A
Side B only	Side B only	Continuous
		play
		(8 times)

6 Press the play button to listen to side A, or the

play button for side B.

To stop playback

Press the stop button.

Note

When removing the tape, press the stop button, and then open the cassette compartment.

Direct operation

Even if an input source other than tape deck is selected, pressing the play button (or the fast wind button) will start playback (or fast winding) directly.

E-27