TUNING OPERATION

1

Receiver

4, 3

3, 2

2

“AM” is for Australia and General models. “MW/LW” is for U.K. and Europe models.

Normally, if station signals are strong and there is no interference, quick automatic-search tuning (Automatic tuning) is possible. However, if signals of the station you want to select are weak, you must tune to it manually (Manual tuning).

Automatic tuning

1 Select the tuner so that “TUNER” appears on the display

by pressing the INPUT selector or button.

2 Select the reception band [FM or AM (MW or LW)] by pressing the BAND button while watching the display.

3 Press the AUTO/MAN’L button so that “AUTO TUNING” appears on the display.(In this mode, stations are received in stereo or monaural automatically.)

4 Press the TUNING UP button to tune to a higher frequency, or press the TUNING DOWN button to tune to a lower frequency.

5 If the station where tuning search stopped is not the desired one, follow step 4 again.

*If the tuning search does not stop at the desired station, change to the Manual tuning method as described below.

*STEREO indicator will illuminate when an FM stereo broadcast with sufficient signal strength is received.

Manual tuning

1 Follow steps 1 and 2 of the Automatic tuning method.

2 Press the AUTO/MAN’L button so that “AUTO TUNING” disappears from the display.

(In this mode, stations are received in monaural.)

3 Press and hold the TUNING UP button to tune to a higher frequency, or press and hold the TUNING DOWN button to tune to a lower frequency.

Release it just before reaching the desired frequency, and then press it repeatedly until the desired frequency appears.

Note

If you tune to an FM station manually, it is received in monaural automatically to increase the signal quality.

English

E-23