Yamaha DSP-A3090 CONNECTING SPEAKER SYSTEMS

For connecting with a monitor TV that uses a 21 pin connector for input (for Europe and U.K. models)

Make a connection as figured below with a commercially available scart-plug connector cable.

		IN
		VCR 2
		OUT
		IN
		VCR 3/DVD
		PAL NTSC
Monitor TV		OUT
	CAN BE USED AS A 2ND
	VCR 3/DVD OUT
	MONITOR OUT, IF SELECTED	MONITOR
	BY SET MENU.	OUT

No connection

VIDEO AUDIO L AUDIO R

Scart-plug connector cable

CONNECTING SPEAKER SYSTEMS

Connect the SPEAKERS terminals to your speakers with wire of the proper gauge, cut as short as possible. If the connections are faulty, no sound will be heard from the speakers. Make sure that the polarity of the speaker wires is correct, that is, + and – markings are observed. If these wires are reversed, the sound will be unnatural and will lack bass. Do not let the bare speaker wires touch each other or any other metal part as this could damage this unit and/or speakers.

NOTE: Use speakers with the specified impedance shown on the rear of this unit.

		Red: positive (+)
2		Black: negative (–)
	3	➀ Unscrew the knob.
		➁ Insert the bare wire.
		[Remove approx. 5mm (1/4”)
1		insulation from the speaker
		wires.]
		➂ Tighten the knob and

secure the wire.

NOTE: Banana Plug connections are also possible (U.S.A., Canada, Australia and General models only). Simply insert the Banana Plug connector into the corresponding terminal.

26