TROUBLESHOOTING
Refer to the table below when this unit does not function properly. If the problem you are experiencing is not listed below or if the instruction below does not help, turn off this unit, disconnect the power cable, and contact the nearest authorized Yamaha dealer or service center.
Problem |
|
|
| Solution | See | |
|
|
| page | |||
|
|
|
|
| ||
|
|
|
| |||
No power | Connect the AC power cable properly. | 14 | ||||
|
|
|
| |||
| Press STANDBY/ON on the front panel of this unit to turn on the | 15 | ||||
| power. |
|
| |||
|
|
|
| |||
No picture | Refer to the manual supplied with your TV for correct Video In | – | ||||
| channel selection. Change the TV channel until you see the DVD |
| ||||
| screen. |
|
| |||
|
|
|
| |||
| Turn on your TV. | – | ||||
|
|
|
| |||
| Make sure that all connections on this unit and on all other | 10 | ||||
| components are secure. |
| ||||
|
|
|
| |||
| If [Component] is set to [Progressive], check that you have connected | 35 | ||||
| this unit to a progressive scan TV through the component video jacks. |
| ||||
| Otherwise, follow the steps below to turn off the progressive scan; |
| ||||
| 1. | Press |
| on the front panel to open the disc tray. |
| |
| 2. | Press CLEAR on the remote control. |
| |||
| 3. | Press “2580” using the numeric buttons |
| |||
|
| control. |
|
| ||
| 4. | Press AUDIO on the remote control. |
| |||
|
|
|
| |||
| If [HDMI Video] is set to other than [Auto], check that the resolution | 36 | ||||
| is supported by the |
| ||||
| Otherwise, follow the steps below to change the setting to [Auto]; |
| ||||
| 1. | Press stwice on the front panel or STOP ( 7 ) twice on the |
| |||
|
| remote control to stop playback. |
| |||
| 2. | Press and hold sand p/eon the front panel at the same time for |
| |||
|
| three seconds. |
| |||
|
|
|
| |||
| If the HDMI indicator flashes orange, check that you have connected | 12 | ||||
| this unit to an |
| ||||
|
|
|
| |||
| Check that the video signal output setting matches the video | 36 | ||||
| connection. |
|
| |||
|
|
|
| |||
Completely distorted picture or | Check that the disc is compatible with this unit. | 3 | ||||
black/white picture |
|
|
|
|
| |
Check that the TV type of this unit is set to match that of the disc and | 16 | |||||
| ||||||
| your TV. If you set the TV type improperly, follow the steps below to |
| ||||
| restore the TV Type setting to the default setting; |
| ||||
| 1. | Press |
| on the front panel to open the disc tray. |
| |
| 2. | Press CLEAR on the remote control. |
| |||
| 3. | Press “2580” using the numeric buttons |
| |||
|
| control. |
|
| ||
| 4. | Press AUDIO on the remote control. |
| |||
|
|
|
| |||
| Check the video connection. | 11 | ||||
|
|
|
| |||
The screen size looks unnatural, | Check that the TV setting of this unit matches the screen aspect ratio | 34 | ||||
or the caption is displayed only | of your TV. |
|
| |||
partially on the TV monitor or is |
|
|
|
|
| |
Change the screen size and the aspect ratio of your TV. | – | |||||
not displayed at all | ||||||
|
|
|
|
| ||
|
|
|
|
|
| |
