12

On-screen menu
The On-screen menu enables you to customize this unit
to suit your requirements.
1Press ON SCREEN on the remote control.
➜The On-screen menu appears on the screen.
2Press k n l h to navigate the On-screen menu and to
change the settings.
3Press ON SCREEN to exit from the On-screen menu.

Features

Dimmer
Adjusts the brightness of the front panel display.
You can use this function if the brightness of the front
panel display disturbs your enjoyment of the home
theater.
Choices: Low, Medium, Normal
Initial setting: Normal
Wake up timer
Turns on the player from standby mode after a preset
amount of time. The timer is then reset to zero. You can
set the timer for up to 600 minutes.
Choices: 0 to 600 minutes
Initial setting: 0
Status window
Displays the current status of the player. Select [Off] to
suppress display of the Status window.
Choices: On, Off
Initial setting: On

Adv.Picture

Allows you to fine-tune the following video parameters.
4:3 Aspect
You can adjust the aspect ratio of the projected images
on the screen. This function is only available for
progressive scan and HDMI video output.
Select [NL_Stretch] for display of 4:3 image on the 16:9
screen with non-linear stretching (Center position of
screen is stretch less than the side).
Select [4:3 PillarBox] to display 4:3 image on the 16:9
screen without stretching.
No aspect ratio adjustment is made when [Auto] is
selected.
We recommend setting the aspect ratio on your TV if the
function is available.
Choices: 4:3 PillarBox, NL_Stretch, Auto
Initial setting: Auto
TrueLife
Produces more dynamic picture by increasing the
picture contrast and the color intensity. This function is
available for progressive scan output only.
Choices: 0 to +7
Initial setting: 0
DCDi
DCDi (Directional Correction Deinterlacing) computes
and tracks the angle of the screen edge to fill in the
missing pixel on the TV screen. DCDi will optimize the
image quality significantly, especially during the slow
motion playback. This function is available for
progressive scan output only.
Choices: On, Off
Initial setting: On
Chroma Delay
The chroma (color) and luminance (brightness) signals
are not synchronized. The Chroma Delay setting allows
you to adjust the advance delay of the chroma signal to
yield a perfectly clear picture. This function is available
for signals output from COMPONENT video jacks
only.
Choices: –3 to +3
Initial setting: 0
Gamma
Enables you to adjust the intensity of the picture non-
linearly. A positive value enables you to bring out low
level detail in dark scenes, while a negative value
emphasizes contrast. This function is available for
signals output from COMPONENT video jacks only.
Choices: –7 to +7
Initial setting: 0

General operation

Preferences

Preferences
Toolbar
Setup
Toolbar
Program
View
Play Option
Search
Slide Show