REMOTE CONTROL TRANSMITTER

Loading the batteries for the remote control transmitter

(See figure 5 on page 5.)
1 Remove the battery compartment cover.
(Slide the cover in the direction of the arrow on the cover.)
2 Insert 2 “AAA” (R03) batteries into the battery compartment.
* Installing the batteries improperly may cause failure.
3 Replace the battery compartment cover.
Precautions for battery use

•Insert the batteries according to the direction indicated in the battery compartment.

•Replace all batteries with new ones at the same time.

•Remove the batteries if they are weak or if the unit is not in use for long periods.

•Don’t mix normal batteries with rechargeable batteries.
LISTENING WITH HEADPHONES

PHONES

CONNECTIONS

Speaker connection

(See figure 7 on page 6.)
Connect each speaker wire to the SPEAKERS terminals.
Cautions

•Do not let the bare speaker wires touch each other as this could damage the power amplifier and/or speakers.

•When connecting the speakers to the unit, be sure to connect the speaker wires properly. Do not make a mistake from the right channel to the left channel and from the plus (+) terminal to the minus (–) terminal.

•Do not connect these SPEAKERS terminals to speakers other than the provided speaker system NX-GX3.

Proper use of the remote control transmitter

(See figure 6 on page 5.)

Aim (within the range of 60° with no obstacles) the remote control transmitter at the remote control sensor and operate as shown.

Notes concerning use

•Replace the batteries if control distance decreases or operation becomes unstable.

•Periodically clean the transmitter window on the remote control transmitter and the sensor on the main unit with a soft cloth.

•Exposing the sensor on the main unit to strong light (especially an inverter type of fluorescent lamp etc.) may interfere with operation. In this case, reposition the main unit to avoid direct lighting.

•Keep the remote control transmitter away from moisture, excessive heat, shock and vibrations.

•The remote control transmitter’s usable range is within 0.2m (8”) and 6m (20’) away from the sensor.

•Be sure that your headphones have a 3.5 mm (1/8”) diameter plug and are between 16 ohms and 50 ohms impedance. Recommended impedance is 32 ohms.

•When headphones are connected, the speakers are defeated automatically. Adjust the VOLUME control for desired volume.

System connection

(See figure 8 on page 6.)

•Make system connections between TCD-GX3 and KMA- GX3 with the provided two system connector cables as figured.

•Connect the CD terminals of TCD-GX3 and KMA-GX3 with the provided pin-plug connection cord.

E-6