Yamaha GX-3 Antenna connection, Connecting the AC supply lead, (See figure 9 on page 6.), (1), (2), (4), (3), Note, Notes, Earth rod, 15m (49 feet), other setting

CONNECTIONS

(1)

AM

ANT

GND

(2)	FM 75Ω
	ANT UNBAL.

15m (49 feet) (4)

(3)

7.5m (25 feet)

Earth rod

AM

ANT

GND

FM 75Ω

ANT UNBAL.

or

Antenna connection

(1) Supplied FM antenna

Connect the FM antenna wire to the corresponding terminal and direct the FM antenna wire to the direction where the strongest signal can be received.

(2) Supplied AM loop antenna

Connect the AM loop antenna wires to the corresponding terminals. Position the AM loop antenna for optimum reception. Place the AM loop antenna on a shelf etc., or install it on the rack or wall with screws (not supplied).

Notes

•When static is still heard even after adjusting the position of the AM loop antenna, try reversing the wire connections (top to bottom).

•Do not place the AM loop antenna on the unit. It will result in noise generation, since the unit is equipped with digital electronics. Place the AM loop antenna away from the unit.

(3) External FM antenna

Use an external FM antenna instead of an indoor FM antenna if you need better reception. Consult your dealer.

(4) External AM antenna

Use an external AM antenna if you need better reception. Consult your dealer.

Note

When using an external AM antenna, be sure to keep the wire of the AM loop antenna connected.

Connecting the AC supply lead

(See figure 9 on page 6.)

•After connecting the speakers and system connectors, plug the AC supply lead into a convenient AC outlet.

•Unplug the AC supply lead from the AC outlet if the unit is not to be used for a long period of time.

English

Switching the frequency step		* If the power is cut off, due to a power failure etc., the
The frequency step can be switched between 9 kHz and 10
kHz by following the procedure described below. If the		setting may be changed to the preset condition. In that
current setting is not proper for your area, switch it to the		case, ascertain the current frequency step on the display,
other setting.		and, if necessary, switch the frequency step again.
1.	Press the POWER switch to turn the power on.
2.	Press the TUNER input selector button.
3.	Press the DISPLAY button to show the current time.
4.	While holding the MEMORY (TIME ADJ) button
	pressed, press the FM/AM button.

E-7