LS9 Editor Owner’s Manual
42
❏BALANCE
This is shown only if the selected MATRIX bus is being used as stereo. It adjusts the left/right volume balance of
the stereo signal. You can set this to the center value by holding down the <Ctrl>(< >) key of your computer
keyboard and clicking this knob.
❏EQUALIZER
This is the same as for the equalizer of a MIX channel (➥ p.39).
❏DYNAMICS1
Except for the fact that the available types are COMPRESSOR, EXPANDER, COMPAND H and COMPAND S,
and that you can select more than one signal as the key-in signal, this is the same as the dynamics for input chan-
nels (➥ p.31).
❏INSERT
Except for the fact that the insert points that can be selected are different, this is the same as for the insert settings
of an input channel (➥ p.35).
❏RECALL SAFE/MUTE SAFE
These are the same as the RECALL SAFE/MUTE SAFE of a MIX channel (➥ p.40).
❏MUTE GROUP
These are the same as the MUTE GROUP of a MIX channel (➥ p.40).
❏Fader
AON
This switches the MATRIX channel on/off.
BFader
This adjusts the output level of the MATRIX channel. A meter indicating the signal level
is shown at the right of the fader, and the current value is shown in the numerical box
immediately below. You can set this to the minimum value (–∞ dB) by holding down
the <Ctrl>(< >) key of your computer keyboard and clicking the fader knob, or set it
to the nominal value (0.00 dB) by holding down the <Ctrl>(< >) key and <Shift> key
and clicking the fader knob.
CCUE
This button cue-monitors the signal of the MATRIX channel.
1
2
3