LS9 Editor Owner’s Manual
79
MFilter Frequency Response Curve
The curve changes depending on the HPF and LPF values.
NReverberation images
These images represent the high-range (10kHz), mid-range (1kHz), and low-range (100Hz) reverberation. These
images change shape depending on the parameter values. The vertical axis represents the level; the horizontal axis
represents reverb time; the shape represents the envelope.
OReverb time curve
This curve represents the high-range (10kHz), mid-range (1kHz), and low-range (100Hz) reverb time.
The curve changes depending on the Reverb Time, Hi Ratio, and Lo Ratio parameter values.
P[Auto Zoom] button
Click the button to automatically adjust the time axis (horizontal axis).
QTime Axis Set button
Use this button to specify the time duration (in seconds) as displayed by the time axis (horizontal axis).
R[] (Zoom Out) button
Click this button to increase the time value (in seconds) as displayed by the time axis (horizontal axis).
As a result, the display zooms out on the horizontal axis.
S[] (Zoom In) button
Click this button to decrease the time value (in seconds) as displayed by the time axis (horizontal axis).
As a result, the display zooms in on the horizontal axis.
T[OUTPUT] meter
This indicates the output level of the effect.
U[MIX] slider
These controls enable you to adjust the mix balance of the dry and wet (effect) sounds.
When the balance is 0%, only the dry sound is output. When the balance is 100%, only the wet sound is output.
The range is from 0 through 100%.
7
8M
N
O
N
N
J
K
L
P
Q
R S
6
T
U
R S
NOTE