UP DN

q

UP

DN

E

ADJUSTING TRIM ANGLE

EMU01401

Power Trim/Tilt Model

w

8Be sure all people are clear of the out- board motor when adjusting the trim/tilt angle, also be careful not to pinch any body parts between the drive unit and clamp bracket.

8Use caution when trying a trim position for the first time. Increase speed gradu- ally and watch for any signs of instabili- ty or control problems.

8Use the power trim/tilt switch located on the bottom engine cowling (if equipped) only when the boat is at a complete stop with the engine off.

701034

The outboard motor trim angle can be

 

 

adjusted operating the power trim/tilt

 

switch 1.

 

To raise the bow (“trim-out”), push the

 

switch UP.

 

To lower the bow (“trim-in”), push the

 

switch DN.

Make test runs with the trim set to different angles to find the position that works best for your boat and operating condi- tions.

NOTE:

To adjust the trim angle while the boat is moving, use the power trim and tilt switch located on the remote control device or tiller handle, if so equipped.

3-17