■Installing batteries in the remote control

1Slide the battery door off the back of the remote control.

2 Insert 4 supplied batteries as indicated on the bottom of the battery compartment.

3 Slide the battery door back on.

After a few seconds, the remote control set up automatically and beeps twice to indicate that it is ready to use.

Cautions

•Insert the batteries in the correct direction by aligning the + and – marks on the batteries with the polarity illustrations (+ and –) inside the battery compartment.

•Change the batteries periodically.

•Do not use old batteries together with new ones.

•Do not use different types of batteries (such as alkaline and manganese batteries) together. Read the packaging carefully as these different types of batteries may have the same shape and color.

•Do not use rechargeable batteries.

•If the batteries have leaked, dispose of them immediately. Avoid touching the leaked material or letting it come into contact with clothing, etc. Clean the battery compartment thoroughly before installing new batteries.

CONTROLS AND FUNCTIONS

■ About changing batteries

the center top of the display. Replace the batteries as soon as possible to ensure perfect performance.

When batteries are running low, the low battery icon

 

 

 

 

flashes at

INTRODUCTION

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Note

• The remote control retains all settings when the batteries have discharged or when you remove and replace them. You will need only to reset the clock.

■Using the remote control

The remote control transmits a directional infrared beam. Be sure to aim the remote control directly at the remote control sensor on the main unit during operation.

30°

30°

Approximately 10 m (33 feet)

 

 

Remote control

Cautions

•When the sensor is covered or there is a large object between the remote control and the main unit, the sensor cannot receive signals.

•The sensor may not be able to receive signals properly when it is exposed to direct sunlight or a strong artificial light (such as a fluorescent or strobe light). In this case, change the direction of the light or reposition the main unit to avoid direct lighting.

•Handle the remote control with care.

•Do not spill water or other liquids on the remote control.

•Do not drop the remote control.

•Do not leave or store the remote control in the following types of conditions:

1 high humidity or temperature such as near a heater, stove or bath

2 dusty places

3 in places subject to extremely low temperatures

English

E-9