Yamaha pmn ■Connecting an MD recorder/tape deck, ■Connecting a turntable, ■Connecting the indoor FM antenna, Connecting the AM loop antenna, E-20

CONNECTIONS

■Connecting an MD recorder/tape deck

OPTICAL IN

MD recorder/tape deck

ANALOG AUDIO	ANALOG AUDIO
OUT	IN

DIGITAL				AUDIO	AUDIO		VIDEO
LD	1	GND	R	PHONO	L R	L	VIDEO S VIDEO
RF	LD						DVD
(AC–3)
	2	1					D–TV
	CD	CD					/LD
	3						CABLE
COAXIAL	DVD
IN
	4	3					SAT
	CABLE	IN
		(PLAY)
	5	CD–R
	CD–R	4					IN
		OUT
OPTICAL		(REC)					VCR 1
	6
OUT
		3
	MD/						OUT
	TAPE	IN
		(PLAY)
	7	MD/TAPE
	CD	4					IN
		OUT
		(REC)					VCR 2
	8
	CD–R	MAIN					OUT

Note

•To connect the OPTICAL (COAXIAL) output jack for an MD recorder with this unit, you can use any of the OPTICAL (COAXIAL) IN jacks by changing the setting for “8 I/O ASSIGN- MENT” on the SET MENU (see page __).

■Connecting a turntable

These jacks are for connecting a turntable with an MM or high output MC cartridge. If you have a turntable with a low output MC cartridge, use an inline boosting transformer or MC-head amplifier when connecting to these jacks.

Turntable

AUDIO OUT

Ground

DIGITAL				AUDIO	AUDIO		VIDEO
LD	1	GND	R	PHONO	L R	L	VIDEO S VIDEO
RF	LD						DVD
(AC–3)
	2	1					D–TV
	CD	CD					/LD
	3						CABLE
COAXIAL	DVD
IN
	4	3					SAT
	CABLE	N

Caution

•The GND terminal does not electrically ground the turntable. It simply reduces noise in the signal. In some cases, you may hear less noise if you do not connect to the GND terminal.

Connecting the antennas

Both AM and FM indoor antennas are included with this unit. In general, these antennas should provide sufficient signal strength. Connect each antenna correctly to the designated terminals.

Indoor FM antenna	AM loop antenna (included)
(included)

■Connecting the indoor FM antenna

Connect the included indoor FM antenna to the FM ANT 75Ω UNBAL. terminal.

TUNER

PR/CR

DVD

D–TV

/LDAM ANT

SAT–GND

MONITOR

OUT

FM ANT

75Ω

■

1

Connecting the AM loop antenna

Set up the AM loop antenna, then connect it.

FRONT

IN

L

FRONT

OUT

Ground (GND terminal)

UNBAL.

For maximum safety and minimum interference, connect the antenna GND terminal to a good earth ground. A good earth ground is a metal stake driven into moist earth.

2

Press and hold the tab to insert the AM loop antenna lead wires into the AM ANT and GND terminals.

A properly installed outdoor antenna provides clearer reception than an indoor one. If you experience poor reception quality, an outdoor antenna may improve the quality. Consult the nearest authorized YAMAHA dealer or service center about the outdoor antennas.

3 Orient the AM loop antenna for the beat reception.

Notes

•The AM loop antenna should be placed away from this unit.

•The AM loop antenna should always be connected, even if an outdoor AM antenna is connected to this unit.

E-20