REMOTE CONTROL FEATURES

Working with modes

When you operate your components, the remote control is in the Use mode. For actions other than operating (like programming buttons,

recording macros, adding components, and so on), you have to switch to the appropriate mode:

For operating components.

For learning commands from other components. *1

For recording macros and setting timers.

For labeling buttons and commands. *1

For adding new components.

For deleting buttons, components and macros. *1

For changing the order in a menu.

For defining brands using the remote control’s database. *2

*1: These actions cannot be made on the RECEIVER and TUNER. To make these actions, copy the RECEIVER and TUNER (see page __) and make actions on the copied one.

*2: You can define brands other than YAMAHA for the RECEIVER and TUNER. However, you cannot operate this unit after defining the other brands. If you want to operate this unit, reset the RC code to “Yamaha-6” for the RECEIVER, and “Yamaha-1” for the TUNER.

Switching to another mode

1 Tap at the bottom of the touch screen.

The Mode menu pops up.

2 Tap the mode you want to use.

The label of the active mode appears on the top center of the touch screen.

You can now work in the selected mode.

Hiding the Mode menu

To prevent accidental changes to the remote control interface and commands, you can hide the Mode menu.

1

Make sure the remote control is in the Use mode.

2

Touch and hold the remote control icon

for a few

 

seconds.

 

The first setup panel appears.

3 Scroll down to the second setup panel.

4 Tap .

The mode menu icon is crossed out.

5 Tap the remote control icon.

The remote control switches to the Use mode.

Note

Repeat steps 1 to 5 to turn the Mode menu back on.

OPERATION

ADVANCED

 

 

English

E-77