Yamaha pmn CAUTION, FCC INFORMATION (for US customers only)

22Wall or Ceiling Mounting – The unit should be mounted to a wall or ceiling only as recommended by the manufacturer.

23Heat – The product should be situated away from heat sources such as radiators, heat registers, stoves, or other products (including amplifiers) that produce heat.

24Outdoor Antenna Grounding – If an outside antenna or cable system is connected to the product, be sure the antenna or cable system is grounded so as to provide some protection against voltage surges and built-up static charges. Article 810 of the National Electrical Code, ANSI/NFPA 70, provides information with regard to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna discharge unit, connection to grounding electrodes, and requirements for the grounding electrode.

Note to CATV system installer:

This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.

IMPORTANT SAFETY INSTRUCTIONS

EXAMPLE OF ANTENNA GROUNDING

MAST	ANTENNA
	LEAD IN
	WIRE
GROUND
CLAMP
	ANTENNA
	DISCHARGE UNIT
	(NEC SECTION 810–20)
ELECTRIC
SERVICE
EQUIPMENT	GROUNDING CONDUCTORS
	GROUNDING CONDUCTORS
	(NEC SECTION 810–21)
	GROUND CLAMPS
	POWER SERVICE GROUNDING
	ELECTRODE SYSTEM
	(NEC ART 250. PART H)
NEC – NATIONAL ELECTRICAL CODE

FCC INFORMATION (for US customers only)

	1. IMPORTANT NOTICE : DO NOT MODIFY THIS UNIT!	Compliance with FCC regulations does not guarantee that
	This product, when installed as indicated in the	interference will not occur in all installations. If this
	instructions contained in this manual, meets FCC	product is found to be the source of interference, which
	requirements. Modifications not expressly approved by	can be determined by turning the unit “OFF” and “ON”,
	Yamaha may void your authority, granted by the FCC, to	please try to eliminate the problem by using one of the
	use the product.	following measures:
	2. IMPORTANT : When connecting this product to	Relocate either this product or the device that is being
	accessories and/or another product use only high quality	affected by the interference.
	shielded cables. Cable/s supplied with this product MUST	Utilize power outlets that are on different branch (circuit
	be used. Follow all installation instructions. Failure to	Utilize power outlets that are on different branch (circuit
	be used. Follow all installation instructions. Failure to	breaker or fuse) circuits or install AC line filter/s.
	follow instructions could void your FCC authorization to	breaker or fuse) circuits or install AC line filter/s.
	follow instructions could void your FCC authorization to	In the case of radio or TV interference, relocate/reorient
	use this product in the USA.	In the case of radio or TV interference, relocate/reorient
	use this product in the USA.	the antenna. If the antenna lead-in is 300 ohm ribbon lead,
	3. NOTE : This product has been tested and found to comply	the antenna. If the antenna lead-in is 300 ohm ribbon lead,
	3. NOTE : This product has been tested and found to comply	change the lead-in to coaxial type cable.
	with the requirements listed in FCC Regulations, Part 15	change the lead-in to coaxial type cable.
	with the requirements listed in FCC Regulations, Part 15	If these corrective measures do not produce satisfactory
	for Class “B” digital devices. Compliance with these	If these corrective measures do not produce satisfactory
	requirements provides a reasonable level of assurance that	results, please contact the local retailer authorized to
	requirements provides a reasonable level of assurance that	distribute this type of product. If you can not locate the
	your use of this product in a residential environment will	distribute this type of product. If you can not locate the
	your use of this product in a residential environment will	appropriate retailer, please contact Yamaha Electronics
	not result in harmful interference with other electronic	appropriate retailer, please contact Yamaha Electronics
	devices.	Corp., U.S.A. 6660 Orangethorpe Ave, Buena Park, CA
	devices.	90620.
	This equipment generates/uses radio frequencies and, if not	90620.
	This equipment generates/uses radio frequencies and, if not	The above statements apply ONLY to those products
	installed and used according to the instructions found in	The above statements apply ONLY to those products
	installed and used according to the instructions found in	distributed by Yamaha Corporation of America or its
	the users manual, may cause interference harmful to the	distributed by Yamaha Corporation of America or its
	the users manual, may cause interference harmful to the	subsidiaries.
	operation of other electronic devices.	subsidiaries.
	operation of other electronic devices.

We Want You Listening For A Lifetime

YAMAHA and the Electronic Industries Association’s Consumer Electronics Group want you to get the most out of your equipment by playing it at a safe level. One that lets the sound come through loud and clear without annoying blaring or distortion – and, most importantly, without affecting your sensitive hearing.

Since hearing damage from loud sounds is often undetectable until it is too late, YAMAHA and the Electronic Industries Association’s Consumer Electronics Group recommend you to avoid prolonged exposure from excessive volume levels.

CAUTION II