Yamaha RX-V2090 CONNECTING SPEAKERS, C+D, Note:, Note:, CAUTION, SPEAKERS A, How to Connect:, Note on main speaker connection:, Note on center speaker connection:

CONNECTING SPEAKERS

Connect the respective speakers to this unit as shown below:

	Main speakers A	Front speakers
	Main speakers A	Right	Left
		Right	Left
Right		Left	Rear speakers
			Right	Left

			SPEAKERS
		FRONT	REAR
	OUTPUT
	FRONT
	OUT
LOW	CENTER
PASS	OUT
fo:200Hz	REAR	8ΩMIN. /SPEAKER	8ΩMIN. /SPEAKER
fo:200Hz	OUT
	OUT
			CENTER
A			C	C
B			C D	D
			C+D
	A OR B: 5ΩMIN. /SPEAKER		C: 8ΩMIN. /SPEAKER
	A+B:l2ΩMIN. /SPEAKER		C+D: 4ΩMIN. /SPEAKER

RightLeft

Center speaker(s)

Main speakers B

Note on main speaker connection:

One or two speaker systems can be connected to this unit. If you connect only one speaker system, connect it to either the SPEAKERS A or B terminals.

Note:

Use speakers with the specified impedance shown on the rear of this unit.

For connecting to the SPEAKER terminals

Note on center speaker connection:

One or two center speakers can be connected to this unit. If you cannot place the center speaker on or under the TV, it is recommended to use two center speakers and place them on both sides of the TV to orient the center sound at the center position. When connecting two center speakers, be sure to press the CENTER speaker switch into the “C+D” position ( ) . When you use a single center speaker, set the switch to the “C” position( ) .

Red: positive (+)

Black: negative (–)

1Unscrew the knob.

2Insert the bare wire. [Remove approx. 5mm (1/4") insulation from the speaker wires.]

3Tighten the knob and secure the wire.

How to Connect:

Connect the SPEAKERS terminals to your speakers with wire of the proper gauge, cut as short as pos- sible. If the connections are faulty, no sound will be heard from the speakers. Make sure that the polarity of the speaker wires is correct, that is, + and – markings are observed. If these wires are reversed, the sound will be unnatural and will lack bass.

CAUTION

Do not let the bare speaker wires touch each other and do not let them touch the metal parts of this unit. This could damage this unit and/or the speakers.

Banana Plug connections are also possible. Simply insert the Banana Plug connector into the corresponding terminal. (Not available on Singapore model.)

Note:

Use only single type banana plug cable.