Yamaha RX-V2090 5MAINÊ CH — MAINÊ IN terminals, 6MAINÊ CH — PREÊ OUT terminals, 7MAIN LEVEL switch, 8ROOM 2 OUT — AUDIO PRE OUT, VIDEO OUT terminals, 0FRONT MIX switch

TAPE 2
REC		LD/TV		MONITOR
OUT		MAIN		OUT
MAIN	5CH	LD/TV		FRONT	ON 5ch
MAIN	DISCRT	LD/TV		FRONT
IN	INPUT	CENTER		MIX	OFF 7ch
	INPUT				OFF 7ch
MAIN CH
PRE		LD/TV
OUT		SURROUND
MAIN	0dB	AUDIO	VIDEO	IN	OUT
LEVEL	-10dB	PRE OUT	OUT
	-10dB
		ROOM 2 OUT		REMOTE CONTROL

5MAINÊ CH — MAINÊ IN terminals

These terminals are for line input to the built-in main channel amplifier. Leave the jumper bars connected to the PREÊ OUT terminals when you use the built-in amplifier.

However, if you drive main speakers with an external stereo power amplifier, remove the jumper bars.

6MAINÊ CH — PREÊ OUT terminals

These terminals are for main channel line output. Leave the jumper bars connected to the MAINÊ IN terminals when you use the built-in amplifier. However, if you drive main speakers with an external stereo power amplifier, remove the jumper bars and connect the input terminals of the external amplifier (MAIN IN or AUX terminals of a power amplifier or an integrated amplifier) to these terminals.

7MAIN LEVEL switch

Normally set to “0Ê dB”. If desired, you can de- crease the output level at the MAIN SPEAKERS terminals by 10Ê dB by setting this switch to “–10Ê dB”.

8ROOM 2 OUT — AUDIO PRE OUT, VIDEO OUT terminals

These terminals output audio and video signals to the equipment in the second room. The signal source is selected using the Room 2 Remote transmitter. Refer to “Connecting to Room 2 Equipment” on page 14.

9REMOTE CONTROL — IN, OUT terminals

IN	This terminal receives the commands from
	the Room 2 Remote transmitter.
OUT	This terminal outputs the commands at the
	IN terminal from Room 2 Remote transmit-
	ter. Refer to “Connecting to Room 2 Equip-
	ment” on page 14.

0FRONT MIX switch

This switch should be set to match the number of speakers in your system. For seven speaker configurations, set it to “7 ch”. For five speaker configurations, set it to “5 ch”.

A5CH DISCRT INPUT terminals

These terminals are used with a Dolby Surround AC-3 decoder. Connect the main audio output of the decoder to the LD/TV MAIN input terminals, the center channel audio output to the LD/TV CENTER input terminal, and the surround audio output to the LD/TV SURROUND input termi- nals.

Note:

5CH DISCRT INPUT terminals can only be used with an AC-3 decoder.

When you use a Dolby Surround AC-3 decoder, the LFE (Low Frequency Effect channel) signal coming from the AC-3 decoder to this unit must be mixed with the main output signal. Refer to your AC-3 decoder’s operating manual for information about mixing these signals mode.