7

7 Select the center channel output mode according to your speaker configuration.

(Refer to “SPEAKER CONFIGURATION” on page 7.)

CENTER

MODE

NORMAL

WIDE

PHANTOM

8

TEST

Press the TEST button to run the Dolby test.

9 Turn up the volume using the remote control transmitter. You will hear a test tone (like pink noise) from the left main speaker, then the center speaker, then the right main speaker, and then the rear speakers, for about two seconds each. The display changes as shown below.

There are two types of tests: Dolby test and DSP test.

• Dolby test:

*

*The test tone from the left rear speaker and the right rear speaker will be heard at the same time.

To adjust the BALANCE, CENTER LEVEL and the REAR LEVEL, go to steps 10~12.

CHAPTER/CH

DISPLAY STOP

VCR 1

—+

PRO LOGIC

ENHANCED

70mm

TV

VCR 2

MOVIE THEATER

THEATER

1

2

3

4

 

 

SURROUND

 

 

V–AUX

SPORTS

STADIUM

ROCK

JAZZ CLUB

5

6

7

8

 

CHURCH

HALL

 

EFFECT

MASTER

9

10

DSP

ON/OFF

VOLUME

 

 

 

 

FRONT LEVEL

 

 

 

—

+

+

 

+

CENTER LEVEL

 

TEST

9

—

+

TIME

 

 

 

DELAY

 

REAR LEVEL

 

MUTING

—

+

—

 

—

RESET

CLEAR

 

 

 

8

Press the TEST button again to run the DSP test.

• DSP test:

The test tone from the left main speaker and the right main speaker, the left front and the right front speaker will be heard at the same time.

To adjust the FRONT LEVEL, go to step 13.

Note:

When the FRONT MIX switch is set to “5ch” (5 channel mode) the DSP test mode is not available.

•If your video monitor is on, the state of the test tone output is also shown by an image of an audio listening room on the screen.

In step 7, when you select the center mode, note the following.

Seven and five speaker configuration

NORMAL: Select this mode when you use a center speaker that is smaller than the main speakers. In this mode, the bass tone will be output from the front main speakers.

WIDE: Select this mode when your center speakers are approximately the same size as the main speakers.

Note:

For seven speaker configurations, the FRONT MIX switch on the rear panel should be set to the “7 ch” setting. For five speaker configurations, the FRONT MIX switch should be set to the “5 ch” setting.

Six and Four speaker configuration

PHANTOM: Select this mode when you do not have a center speaker. The center channel sound will be output from the left and right main speakers.

17