Connections
Connecting the FM and AM antennasBoth FM and AM indoor antennas are supplied with this unit. In general, these antennas should provide sufficient signal strength. Connect each antenna correctly to the designated terminals.
Notes
•The AM loop antenna should be placed away from this unit.
•A properly installed outdoor antenna provides clearer reception than an indoor one. If you experience poor reception quality, install an outdoor antenna. Consult the nearest authorized Yamaha dealer or service center about outdoor antennas.
•The AM loop antenna should always be connected, even if an outdoor AM antenna is connected to this unit.
Outdoor AM antenna | AM loop | Indoor FM | |||||||
Use a 5 to 10 m (16 to 32 ft) of | antenna | antenna | |||||||
(supplied) | (supplied) | ||||||||
outdoors from a window. |
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
ANTENNA
AM
GND
FM
75
UNBAL.
IN | MD/ |
(PLAY) | |
|
|
Ground
For maximum safety and minimum interference, connect the antenna GND terminal to a good earth ground. A good earth ground is a metal stake driven into moist earth.
Once all connections are complete, plug the power cable into the AC wall outlet.
Power cable
(U.S.A. model)
To the AC wall outlet
Turning on and off the power■Turning on this unit
Press 1STANDBY/ON (or L POWER) to turn on this unit.
y
When you turn on this unit, there will be a 4 to
■Set this unit to the standby mode
Press 1STANDBY/ON (or M STANDBY) to set
this unit to the standby mode.
In the standby mode, this unit consumes a small amount of power in order to receive infrared signals from the remote control.