Recording

Recording adjustments and other operations are performed from the recording components. Refer to the operating instructions for those components.

Notes

When this unit is set to the standby mode, you cannot record between other components connected to this unit.

The settings of TONE CONTROL (see page 29) and VOLUME settings, speaker levels (see page 29) and the sound field programs (see page 31) do not affect recorded material.

The source connected to the MULTI CH INPUT jacks of this unit cannot be recorded.

The XM Satellite Radio signals cannot be output at the AUDIO OUT (REC) jacks.

Digital signals input at the DIGITAL INPUT jacks are not output at the analog AUDIO OUT (REC) jacks for recording. Therefore, if your source component is connected to provide only digital signals, you cannot record the source.

A given input source is not output on the same OUT (REC) channel.

Once you have connected a recording component to this unit, keep the component turned on while using this unit. If the component is turned off, this unit may distort the sound from other components.

Check the copyright laws in your country to record from CDs, radio, etc. Recording of copyrighted material may infringe copyright laws.

y

Do a test recording before you start an actual recording.

If you play back a video source that uses scrambled or encoded signals to prevent it from being dubbed, the picture itself may be disturbed due to those signals.

1Turn on all the connected components.

2Press DINPUT l/ hrepeatedly (or press one of the input selector buttons (C)) to

select the source component you want to record from.

3Start playback on the selected source component or select a broadcast station.

4Start recording on the recording component.

42 En