y

When performing these operations with the remote control, press

CXM to select “XM” as the input source.

■All Channel Search mode

1Press 2SEARCH MODE (or P SRCH

MODE) repeatedly to select “ALL CH SEARCH”.

2Press 5PRESET/TUNING/CH l/ h(or

G PRESET/CH k/ n) repeatedly to search for a channel within all channels.

y

•You can search for a channel quickly by pressing and holding

5PRESET/TUNING/CH l/ h(or G PRESET/CH k/ n).

•To display the XM Radio ID number displayed in the front panel display, select channel “0”.

■Category Search mode

1Press 2SEARCH MODE (or P SRCH

MODE) repeatedly to select “CAT SEARCH”.

2Press 4CATEGORY (or G A-E/CAT.l/ h) repeatedly to change the channel category.

3Press 5PRESET/TUNING/CH l/ h(or

G PRESET/CH k/ n) repeatedly to search for a channel within the selected channel category.

y

You can search for a channel quickly by pressing and holding

5PRESET/TUNING/CH l/ h(or G PRESET/CH k/ n).

■Preset Search mode

Prior to selecting a preset channel in the Preset Search mode, you must preset XM Satellite Radio channels. For details, see “Setting XM Satellite Radio preset channels” on page 40.

y

All preset channels (A1 to E8) recalls “001 Preview” by the initial factory setting.

1Press 2SEARCH MODE (or P SRCH

MODE) repeatedly to select “PRESET SEARCH”.

2Press 4CATEGORY (or G A-E/CAT.l/ h) repeatedly to change the preset channel group (A to E).

XM Satellite Radio tuning

3Press 5PRESET/TUNING/CH l/ h(or

G PRESET/CH k/ n) repeatedly to change the preset channel number (1 to 8).

y

You can also select the preset channel number directly by pressing the numeric buttons (1 to 8) on the remote control.

■Direct Number Access mode

1Press P SRCH MODE repeatedly to select “ALL CH SEARCH” or “CAT SEARCH”.

2Press the numeric buttons (V) to enter the desired three-digit channel number.

For example, to enter the number 123, press the numeric buttons as shown below.

l

h

ENHANCER

1

2

3

The display changes as follows.

<XM> --1

<XM> -12

<XM>123

y

•To enter a one-digit or two-digit channel number, press the numeric buttons (V) and then press W ENT. to confirm the input number. Instead of pressing W ENT. to tune into the

channel immediately, you can wait a few seconds until this unit confirms the entered channel number.

•If no button is pressed within a few seconds after you enter a one-digit or two-digit number, this unit automatically confirms the entered channel number.

•Pressing a button other than the numeric buttons (V) or

W ENT. cancels the Direct Number Access mode procedure.

OPERATION

BASIC

 

 

English

39 En