Connecting the FM and AM antennas
Both FM and AM indoor antennas are included with this unit. In general, these antennas should provide sufficient signal strength. Connect each antenna correctly to the designated terminals.
AM loop antenna
Indoor FM antenna (included) (included)
Ground (GND terminal)
For maximum safety and minimum interference, connect the antenna GND terminal to a good earth ground. A good earth ground is a metal stake driven into moist earth.
■Connecting the AM loop antenna
1Set up the AM loop antenna.
2Press and hold the tab to insert
the AM loop antenna lead wires into the AM ANT and GND terminals.
3Orient the AM loop antenna for the best reception.
CONNECTIONS
Notes
•The AM loop antenna should be placed away from this unit.
•The AM loop antenna should always be connected, even if an outdoor AM antenna is connected to this unit.
•A properly installed outdoor antenna provides clearer reception than an indoor one. If you experience poor reception quality, an outdoor antenna may improve the quality. Consult the nearest authorized YAMAHA dealer or service center about outdoor antennas.
■Connecting the
1Open the cover of the
included 75-ohm/300-ohm antenna adapter.
2Cut the external sleeve
of the | 11 | Unit: | |
cable and prepare it for | 8 | mm | |
6 | |||
connection. |
| ||
|
| ||
3 Cut the lead wire and |
|
| |
remove it. |
| Lead wire |
4Insert the cable
wire into the slot, | Clamp | Clamp |
and clamp it with |
|
|
pliers. |
|
|
| Insert wire into |
|
| slot |
|
5 Snap the cover into place.
PREPARATION
English
19
